XDJ-RX2 works with other MIDI-compatible software besides rekordbox, by assigning MIDI message. Please refer to the list of MIDI message to find mapping values of all buttons and knobs. To assign MIDI message to all software function, please refer to your manufacturers' software manual. Xdj rx2 flac & alac Could you please comment if the lack of FLAC or ALAC support on XDJ RX2 is a hardware limitation, like that on the original XDJ RX or if this is patchable (or planning to be added) in the future. Have your speakers connected to the rear-panel of the XDJ-RX2 and click 'Use SoundCard' for VirtualDJ to apply the pre-defined audio setup with the built-in sound card of the XDJ-RX2 You can still change that from Settings-AUDIO tab. Click to OK on both windows MIDI MODE On the XDJ-RX2: Press the MIDI button at the left side of the Display.

46. PAD MODE. Press any of the 4 available Pad mode buttons to set the Pads to Hotcues, Loop, Loop Roll and Beatjump mode.
    Hold SHIFT and then press any of the 4 available Pad mode buttons to set the Pads to Saved Loops, Sampler, Slicer and Keycue mode.
    
47. PADS. The 8 Pads offer different functionality depending on the selected mode.
    

The Parameters of each mode can be adjusted from the VirtualDJ GUI (Pads section)
Read further details about Pads in the VirtualDJ 8 manual

HOTCUES

LOOP

LOOP ROLL

Beatjump mode

Saved Loop mode

SAMPLER

Use the Parameter arrow-buttons from the GUI of VirtualDJ (Pads section) to select the Sampler Bank (previous/next).

SLICER

Hold SHIFT and then use the Pads to repeat the memorized Slices (the Slices played/repeated last time)
Use the Parameter arrow-buttons from the GUI of VirtualDJ (Pads section) to adjust the length of the Loop applied to the slice. or adjust the step of the Slices

Key-Cue mode

Hold SHIFT down and then press the BEAT JUMP mode button to set the PADs to KeyCue mode (button will be lit yellow) and automatically load the KeyCue Pads page in VirtualDJ GUI

Pioneer Xdj Rx2 Software Manual

Dj Xdj Rx2

In this mode, the Pads trigger a selected Hotcue point (or the Temporary Cue if none selected or not available) at a selected Key semitone (from -7 to +7).
8 different pages/banks are offered with various semitone values to use and a 0 value (reset key to tis original value) is always offered in all pages.
Hold SHIFT and then select a Hotcue for the Key pads to trigger. Each time a Pad is pressed, the track will jump to that Hotcue point and will also alter the Key of the track to the value designated by it assigned value.
Use the Parameter arrow-buttons on the GUI of VirtualDJ (Pads section) to

Pioneer Xdj Rx2 Software Download

adjust the Key of the track without trigger a Hotcue.

Pioneer Dj Xdj Rx2

or select a different page/bank

Pioneer Xdj Rx2 Software

with different key semitone values.

Xdj Rx2 Bugs

Microphone